For Railway Transporting Tools Rail Transporting Device
XBYII Rail Transporting Device is applicable to transport the material around the rail, such as rail, concrete sleeper and other online material supplies. The device can be used by pulling to transport materials without any power source. The walking wheel adopts nylon material, auxiliary chain and the implementation of the insulation performance is good, does not affect the track circuit. It have weight light,fast down the road, on bridges and tunnels in difficult places, it may leave the road at any time without invasion to avoid the train safety.
- Product Introduction
Technical Parameters
1.Max pulling force：2T(1 group)
2.operation force：20kg/single 、10kg/double
3.weight： 72kg
Rail Transporting Device is applicable to transport the material around the rail, such as rail, concrete sleeper and other online material supplies. The device can be used by pulling to transport materials without any power source. The walking wheel adopts nylon material, auxiliary chain and the implementation of the insulation performance is good, does not affect the track circuit. It have weight light,fast down the road, on bridges and tunnels in difficult places, it may leave the road at any time without invasion to avoid the train safety.
The basic structure and working principle
Working principle: rotating the crank, the power through a gear reducer, ratchet direction limit, delivered to the drum, driven by the guide pulley to pull the material or unload the rail.
Basic: 1. Handle 2. Pawl 3. Big load lift crank shaft 4. Small load crank shaft 5. Nylon wheel 6. Auxiliary supporting hook 7. Pulling handle 8. Rail sling hook 9. Sleeper lifting tool 10. Leaving lifting tool
Caution
1.The operation should abide to railway safety rules.
2.When lifting 25 meters rail, must be two or three equipment to work at the same time, staff are not allowed to stand in front of the material.
3.Should always check the rope clamp situation.
4.Use longer rope when transport the material is far from distance, prohibit of overload.
5.During working or quickly off road, must take the swing handle from the crank shaft first then pull out the ratchet, in case of hurt the staff.
6.When lifting materials, the pushing stiffeners should be vertical upward.
7.Check the pawl and the ratchet wheel before use, ensure they are in the same direction as shown in figure 2.
8.If pawl and ratchet was abnormal, should be replaced immediately.
9.Pay attention to personal safety.
Hot Tags: for railway transporting tools rail transporting device, China, manufacturers, suppliers, made in China, rail car automated guided vehicle, rail car connected vehicle, rail car gondola, rail car service, rail car driverless vehicle, rail car crew
